Be sure to check the floor pad. It should also be no more than 1-inch thick, snug-fitting, and firm enough to protect your baby from falling or rolling into the loose mesh pocket that can form between the edge of the floor panel and side of the play yard (a suffocation hazard). We think it's safer when models have slots on the floor that allow the mattress's Velcro strips to be inserted and secured on the outside of the play yard, making it difficult for a baby or toddler to lift the mattress and possibly become trapped under it. Avoid models with a mattress that fastens to the bottom of a play yard only with Velcro pads that a child can access from the inside. Use only the mattress or pad that comes with your play yard.
• It's best to remove the bassinet and the changing station entirely, or if you have a hinged changing station, at least be sure to flip it to the outside when your baby is playing in the play yard. A baby's neck can become trapped between the side rail and the bassinet or changing station and children have died in play yards when that has happened. Be aware that another child can flip a hinged bassinet back onto the play yard while your baby is inside—another hazard.
I used this playpen at work for a year. Purchased when my daughter was almost a year old. I had to take it in and out of my car everyday at work and I was worried that it wouldn't hold up due to it being hollow plastic. I was pleasantly surprised! It held up so well that I will be able to use it again for the next baby. My daughter is now two and knows how to stack things so she can climb out and she's tall. However she has never been able to figure out how to unlock the gate. All the toys on the toy panel still work and have held up despite my daughter being rough with them. None of the connector pegs have come off during transport. I really worried they would pop off since they weren't solid and were jostled in my car all the time!
Nice to keep baby out of trouble at home. Once he became mobile we had to do an "upgrade" as we noticed he was starting to hit his head on the X shaped metal bars. We tried some alternatives but the best so far was wrapping the metal bars with pool noodles (see picture). You'll need 8 pool noodles and some cuts (buy some extra in case you mess up). Use 2/3 of a pool noodle to wrap the internal bars and the remaining 1/3 to wrap half of the external bar. The pieces will also need a longitudinal cut along the length to fit the bar in. You'll also need some small cuts in the middle of the longer piece to fit the center rivet, where the mesh is attached to the bars. We got the pool noodles at the dollar store nearby for less than $10 and since ... full review
×