I had been using the colorful 8-panel North States baby gate from the time by babies were 6 months-one year. But once they were learning to climb the gate with their toes in the little holes (and use their baby muscles to pull the entire gate down), I knew it was time for a more sturdy option. This fit the ticket, it's not as large as the North States - but plenty large enough for toddler twins (with more than enough room for mom and/or dad to play in with them as well). It's also a few inches shorter in height to our old play pen, but it's not an issue with our 28 & 29 inch boys because the openings/holes on the play pen are low enough that when they step on them, it's more than tall enough to make them unable to climb over. ... full review
Love this playpen! Sturdy, bright and fun. Has a few toys inside that even bigger kids (3yr olds) want to play in it. Big enough for multiple children to play in it at one time. it has suction cups under each panel that I'm hoping will work good on our tile floors when they get installed in a few weeks. I found a mat (patchwork toddler play mat) that is 1.5 inches thick and fits perfectly inside that will vision little ones falls.
If you’re in need of a larger playpen, the Delta Children 36″ x 36″ Playard may be a great option for you. At three foot square, this playpen gives baby lots of room to play and explore. It also has fun animal designs that children love. This playpen comes with a mattress and carrying bag, and it folds compactly for storage and travel. This playpen is on the heavier side at 28 pounds, and some consumers report that setup and breakdown is more difficult than with other models. (Check out the video below to see how to break it down for storage.) This playpen is not recommended to use for sleeping as it does not come with a bassinet feature. Some consumers have reported issues with the bottom pad not lying flat.
Be sure to check the floor pad. It should also be no more than 1-inch thick, snug-fitting, and firm enough to protect your baby from falling or rolling into the loose mesh pocket that can form between the edge of the floor panel and side of the play yard (a suffocation hazard). We think it's safer when models have slots on the floor that allow the mattress's Velcro strips to be inserted and secured on the outside of the play yard, making it difficult for a baby or toddler to lift the mattress and possibly become trapped under it. Avoid models with a mattress that fastens to the bottom of a play yard only with Velcro pads that a child can access from the inside. Use only the mattress or pad that comes with your play yard.
Nice to keep baby out of trouble at home. Once he became mobile we had to do an "upgrade" as we noticed he was starting to hit his head on the X shaped metal bars. We tried some alternatives but the best so far was wrapping the metal bars with pool noodles (see picture). You'll need 8 pool noodles and some cuts (buy some extra in case you mess up). Use 2/3 of a pool noodle to wrap the internal bars and the remaining 1/3 to wrap half of the external bar. The pieces will also need a longitudinal cut along the length to fit the bar in. You'll also need some small cuts in the middle of the longer piece to fit the center rivet, where the mesh is attached to the bars. We got the pool noodles at the dollar store nearby for less than $10 and since ... full review
×