The Cosco Funsport Play Yard is a very affordable playpen option for babies that is simple to set up; the instructions say it takes less than a minute. This playpen comes equipped with wheels on one side to easily move it from room to room, and it also folds up easily and comes with a bag for transport. This playpen doesn’t come with a mattress; instead it has a lightly padded bottom piece for baby to play on. Some consumers have reported issues with the platform not resting flat on the bottom of the playpen. There are a few reports of confusion over how to fold the playpen up. (See the video below for a quick tutorial and some tips to make it easier!) Finally, make sure you order this playpen with plenty of lead time, as it is not eligible for Prime shipping and takes one to two months to ship out.
We have a new puppy. We got one of those wire pens for him. Unfortunately, he almost immediately figured out he could climb the cross wires! He was out in a flash. SO we got this pen. It is almost perfect. It will be perfect when we get done. The bars are in general about two inches wide. Those he cannot get through. But the gate is a different matter. The bars around the hinge and latch areas are about a half inch wider--probably to accommodate the mechanics of the gate latch and hinge. But that is just enough wider that our puppy can get his shoulders through. Maybe the rest of his body, but we intervened.
Some attach to the longer top rail—you have to remove them to get them out of the way. Others simply rest on the long rails and are hinged at one shorter side rail so the changing station can be flipped over the rail to hang at the outer side of the play yard. We think it's safer to remove the changing table when not in use so it is out of reach of your baby and any other children. In addition, it is always better to have an active means of attachment to the frame—that is you have to click, snap, button, or strap a changing table or bassinet into place rather than just have it resting on a frame.
Nice to keep baby out of trouble at home. Once he became mobile we had to do an "upgrade" as we noticed he was starting to hit his head on the X shaped metal bars. We tried some alternatives but the best so far was wrapping the metal bars with pool noodles (see picture). You'll need 8 pool noodles and some cuts (buy some extra in case you mess up). Use 2/3 of a pool noodle to wrap the internal bars and the remaining 1/3 to wrap half of the external bar. The pieces will also need a longitudinal cut along the length to fit the bar in. You'll also need some small cuts in the middle of the longer piece to fit the center rivet, where the mesh is attached to the bars. We got the pool noodles at the dollar store nearby for less than $10 and since ... full review