Consumer Reports is an independent, non-profit organization dedicated to helping consumers. We make it easy to buy the right product from a variety of retailers. Clicking a retailer link will take you to that retailer’s website to shop. When you shop through retailer links on our site, we may earn an affiliate commission – 100% of the fees we collect are used to support our mission. Learn more. Our service is unbiased: retailers can’t influence placement. All prices are subject to change.
This sleek, Dutch-designed playard will fit right into a modern home. It’s one-hand folding system makes for an easy setup, especially since the upper cot folds with the frame. The cushy quilted mattress turns the playard into a bassinet for your baby and then later into a dreamy napping spot for your toddler. And it comes in grown-up colors, too: red, black, gray, navy and khaki.
Be sure to check the floor pad. It should also be no more than 1-inch thick, snug-fitting, and firm enough to protect your baby from falling or rolling into the loose mesh pocket that can form between the edge of the floor panel and side of the play yard (a suffocation hazard). We think it's safer when models have slots on the floor that allow the mattress's Velcro strips to be inserted and secured on the outside of the play yard, making it difficult for a baby or toddler to lift the mattress and possibly become trapped under it. Avoid models with a mattress that fastens to the bottom of a play yard only with Velcro pads that a child can access from the inside. Use only the mattress or pad that comes with your play yard.
Nice to keep baby out of trouble at home. Once he became mobile we had to do an "upgrade" as we noticed he was starting to hit his head on the X shaped metal bars. We tried some alternatives but the best so far was wrapping the metal bars with pool noodles (see picture). You'll need 8 pool noodles and some cuts (buy some extra in case you mess up). Use 2/3 of a pool noodle to wrap the internal bars and the remaining 1/3 to wrap half of the external bar. The pieces will also need a longitudinal cut along the length to fit the bar in. You'll also need some small cuts in the middle of the longer piece to fit the center rivet, where the mesh is attached to the bars. We got the pool noodles at the dollar store nearby for less than $10 and since ... full review